|
[Sponsors] |
Specifying 'Stop Iteration' for SAS Averaging |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 15, 2013, 12:20 |
Specifying 'Stop Iteration' for SAS Averaging
|
#1 |
Member
|
When running a SAS-SST turbulence model I recieve the following notice...
http://imgur.com/vfzP3YE I know it is only a notice, and the simulation continues to run, but in case this is a part of some of the instability I see I would like to know where and how to adjust this stop iteration setting. But the information is not in any Ansys guide! Does anyone have experience with where this setting is and how to assign an appropriate value? Thank you |
|
November 18, 2013, 02:56 |
|
#2 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
If you are not interested in the Reynolds stresses then ignore it. In order to get statistically correct Re stresses (e.g. remove initial startup effects) one can delay the start of the averaging at: Output control/Trn stats/<new> /start/stop iteration list.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How To Stop The Iteration Process? | sefde | FLUENT | 9 | November 19, 2023 03:02 |
When to stop the iteration? | oldisbest | FLUENT | 7 | May 20, 2013 00:50 |
Stop iteration and continuation of the process | martapajon | OpenFOAM Running, Solving & CFD | 3 | November 5, 2007 15:06 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 22:30 |
How to stop iteration with TUI? | sophie | FLUENT | 4 | November 23, 2006 05:18 |