|
[Sponsors] |
April 20, 2014, 23:42 |
How to generate force historical file?
|
#1 |
Member
Antoni Alexander
Join Date: Nov 2009
Posts: 43
Rep Power: 16 |
Hello everyone,
I am using terminal command line on Linux cluster to run cfx. Since there is no graphics, so I can not see the point monitor such as lift drag defined in cfxpre. Then I tried to find a way to output the force historical file, but it turned no good. So, has anybody ever faced the same problem? Could cfx generate the monitor point in a file? And how? Any suggestions will be appreciated! Best regards. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] OpenFOAM Installation for navalFoam | sachinlb | OpenFOAM Community Contributions | 22 | July 28, 2017 05:26 |
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error | FerdiFuchs | OpenFOAM Community Contributions | 27 | April 16, 2014 15:14 |
patch error OF v2.2.2 mac | hewei | OpenFOAM Installation | 4 | November 30, 2013 16:55 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |