 |
 |
 |
|
|
|
[Sponsors] | ||||
September 9, 2014, 06:36
|
Rotational Periodicity Problem in CFX
|
#1 |
|
Senior Member
Bharath kumar
Join Date: Apr 2009
Posts: 169
Rep Power: 17  |
Hi to all,
I am doing Single Blade Path Stage analysis. I had a doubt on Rotaional Periodicity meshing.I am using ICEM CFD Tetramesh for the Stator & Rotor geometry. Now the query is, Whether the two Periodic faces have to meshed with 1:1 Periodic connectivity or GGI is sufficient for CFX? Thanks in advance Regards Bharath |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass imbalance problem in multiphase water and steam CFX case | Antech | CFX | 1 | October 26, 2020 04:03 |
| Convergence problem of CFX when comparing with FLUENT with same mesh | guxin7005 | CFX | 8 | May 22, 2014 15:13 |
| cfx mesh problem... | mactech001 | ANSYS Meshing & Geometry | 0 | November 5, 2009 02:19 |
| problem in displaying surfaces in CFX | haho | CFX | 1 | July 5, 2009 19:25 |
| CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |
Linear Mode
