Solver finished normally without convergence before max. Number of iterations

oddo90 · January 1, 2015, 14:03

Hello,

I have a question concerning convergency . In my case the solver stops running before reaching the maximum Number of iteration steps, but not all of the variables does converge. The Message box says " run has finished normally"

Could any One Tell me whx this Happens and what it means? I searched after an answer in the Forum and the manuals, but I didn't find anything. Thank you very much in advance!

Best Regards

oddo

ghorrocks · January 1, 2015, 23:52

The output file will tell you why it stopped. Just look back further into the final stages of the output file.

January 1, 2015, 14:03	Solver finished normally without convergence before max. Number of iterations	#1
oddo90 New Member Join Date: Jun 2014 Posts: 1 Rep Power: 0	Hello, I have a question concerning convergency . In my case the solver stops running before reaching the maximum Number of iteration steps, but not all of the variables does converge. The Message box says " run has finished normally" Could any One Tell me whx this Happens and what it means? I searched after an answer in the Forum and the manuals, but I didn't find anything. Thank you very much in advance! Best Regards oddo

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
calculation stops after few time steps	sivakumar	OpenFOAM Running, Solving & CFD	7	March 17, 2013 06:37
SLTS+rhoPisoFoam: what is rDeltaT???	nileshjrane	OpenFOAM Running, Solving & CFD	4	February 25, 2013 04:13
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 21:14
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36

January 1, 2015, 23:52		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,728 Rep Power: 143	The output file will tell you why it stopped. Just look back further into the final stages of the output file.