[Nurzhan]

Dear experts,

I am using different design points in the ANSYS workbench to study a heat transfer problem. At each new design point, I would like to measure temperature at three particular points within my geometry, but the positions of the points of interest are different at each design point.

Currently, I get my results using CFD Post (specifying the coordinates of the points, then plotting a graph (Temperature vs Time), and exporting the result into a csv file). However, if I have many design points, it will take a lot of time to access to the result files using my current method.

Therefore, I would appreciate any suggestion about an optimisation of the result collection procedure?

Is there any possibility within ANSYS Workbench 15.0 to set the coordinates of the points of interest into each design point?

Ideally, I want to collect temperature of the points of interest out of all design points into one csv file.

Best regards,
Nurzhan