|
[Sponsors] |
December 17, 2015, 02:06 |
CARBURIZING process
|
#1 |
Senior Member
Marcin
Join Date: May 2014
Location: Poland, Swiebodzin
Posts: 232
Rep Power: 13 |
Hello
Have anyone experience with carburizing modelling in ansys cfx or have anyone tutorials to this process Best regards
__________________
Quick Tips and Tricks, Tutorials FLuent/ CFX (CFD) https://howtooansys.blogspot.com/ |
|
December 18, 2015, 01:15 |
|
#2 |
Senior Member
Marcin
Join Date: May 2014
Location: Poland, Swiebodzin
Posts: 232
Rep Power: 13 |
Have anyone experience with carburizing process in ansys cfx??
__________________
Quick Tips and Tricks, Tutorials FLuent/ CFX (CFD) https://howtooansys.blogspot.com/ |
|
December 18, 2015, 05:28 |
|
#3 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,728
Rep Power: 143 |
It is a pretty specialised process, I do not like your chances of finding anybody who has done it. You might have more luck with ANSYS support.
But the basic principle is carbon from a source (usually a flame) enters some steel and diffuses in. CFX has models for all these processes - so far so good - but the devil is in the detail of course. |
|
December 21, 2015, 05:39 |
|
#4 |
Senior Member
Marcin
Join Date: May 2014
Location: Poland, Swiebodzin
Posts: 232
Rep Power: 13 |
some tutorials with diffusitivity ??
__________________
Quick Tips and Tricks, Tutorials FLuent/ CFX (CFD) https://howtooansys.blogspot.com/ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The fl process could not be started because of UDF | majid_kamyab | Fluent UDF and Scheme Programming | 6 | December 15, 2015 08:42 |
Setting process affinity: failed opening libc! | Jonathan | FLUENT | 1 | July 7, 2014 17:35 |
Problem running in parralel | Val | OpenFOAM Running, Solving & CFD | 1 | June 12, 2014 02:47 |
error 262144 and unexpected disconnect when run on 2 nodes | Emily1412 | SU2 Installation | 1 | April 10, 2014 17:08 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |