 |
 |
 |
|
|
|
[Sponsors] | ||||
July 8, 2016, 11:38
|
Restitution coefficient (kinetic theory)
|
#1 |
|
Member
|
Can you suggest where is setup of set the restitution coefficient?
I have some message in pre CFX "In Analysis 'Flow Analysis 1' - Domain 'Pipes': If kinetic theory is active for fluid 'qua1', then the restitution coefficient must also be set." |
|
|
|
|
|
July 22, 2016, 17:44
|
|
#2 |
|
New Member
Zahoor Hussain
Join Date: Oct 2015
Posts: 22
Rep Power: 10  |
in your fluid domain when you create materials then for solid particle select dispersed solid it will automatically show you the tab for restitution coefficient.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
| Use of restitution coeff without kinetic theory | Kushagra | CFX | 7 | January 27, 2015 13:36 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| Kinetic Theory in Multiphase | mtl | Main CFD Forum | 0 | June 3, 2009 22:54 |
| Automotive test case | vinz | OpenFOAM Running, Solving & CFD | 98 | October 27, 2008 08:43 |
Linear Mode
