|
[Sponsors] |
August 7, 2001, 08:54 |
Boundary problem
|
#1 |
Guest
Posts: n/a
|
Hi,
I am simulating a ventillated installation with heat transfer and k-epsilon model. I imposed a boundary condtion with a certain outer temperature. But I saw a very funny result on the post processer. The whole layer of cell at the boundary has the same temperature. Is this because my grid is course? or there is something wrong due to other reasons.How does CFX4.3 understands boundary? Is it an infinitisimal outer face or the whole cubic cell at the pheriphery of the room? Thanks CFX lover |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDS problem with wall boundary condition | Alex F. | FLUENT | 15 | September 21, 2015 10:28 |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 01:35 |
Boundary layer meshing problem in Gambit | Crystal | Main CFD Forum | 0 | June 12, 2009 15:32 |
problem boundary profiles | Rainy | FLUENT | 0 | April 24, 2008 06:30 |
GAMBIT problem with 3D Boundary Layer when meshing | Anthony Haroutunian | FLUENT | 2 | March 26, 2008 03:02 |