Error: #001100279

Tara

Hello,

Perhaps some of you have seen this error message before and can give me some insight to what is wrong?

I get the below error when I try to run the solver: I have no error messages or problems when I create my definition file in CFXbuild. I also have no problems when I look at the mesh in CFX Visualize. CFXSolve is not even reading in the mesh. Even if I do have unphysical BCs or ICs defined (which I checked over 4 times and am pretty sure that I don't), I would think that CFXSolve would first read in the mesh, then read in the conditions, then try to solve and blow up at the first iteration. In this case, it doesn't even get to reading in the mesh.

Well, any bit of information that you could give me would be appreciated.

Thanks, Tara

************************************************** *****

| Job Information | Run mode: serial run

Host computer: ******

Job started: Tue Nov 13 09:27:49 2001

| ERROR #001100279 has occurred in subroutine ErrAction. Message Floating point Overflow exception: | ERROR #001100279 has occurred in subroutine ErrAction. |Message: | Stopped in routine c_fpx_handler |

An error has occurred in cfx5solve:

The CFX-5 Solver exited with return code 2

End of solution stage.

This run of the CFX-5 Solver has finished. ************************************************** ****