 |
 |
 |
|
|
|
[Sponsors] | ||||
May 4, 2002, 20:43
|
How to ddefine the rotation axis?
|
#1 |
|
Guest
Posts: n/a
|
Hi,
If a machine rotate about the "Z" axis, can I define the rotation axis in the "inflow boundary condition" as "DX=0,DY=0,DZ=1"? I saw one case run by others. The definition is "Da=2.5, Dr=-12, Dt=0"(Cyclindrical). How does this work? The software I use is TASCflow 210. Thanks a lot! oldarmy |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specifying axis of rotation | David Banks | FLUENT | 5 | November 21, 2016 09:38 |
| Rotation Axis in Fluent | arapha | FLUENT | 3 | November 8, 2016 22:44 |
| Axis of rotation for centrifugal compressor | Mattia | FLUENT | 4 | October 22, 2007 12:05 |
| Relief Plots in CFX | Michael | CFX | 15 | June 30, 2006 09:01 |
| Axis of rotation | Dunga | CFX | 4 | May 11, 2003 11:44 |
Linear Mode
