|
[Sponsors] |
July 19, 2017, 22:37 |
write compressed data failed
|
#1 |
New Member
jongbeom seo
Join Date: Jul 2015
Posts: 4
Rep Power: 10 |
Hi all
i`m working on the simulation of turbine which has 9M nodes using linux cluster. cluster consists of 11 compute nodes having 4 cores, 64G RAM for master and so on. Problem is, when the simulation is done by approaching to target iteration, cfx could not write result file with error message like below: ------------------------------------------------------- ERROR #001100279 has occurred in subroutine ErrorAction. Message: iocnt: write compressed data failed ------------------------------------------------------- This message is showed about a hundred times. I`m looking forward to get your answer. thank you |
|
July 20, 2017, 04:53 |
|
#2 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
is there by any chance an "uncommon" letter (üöä etc) or symbol in the write path? AFAIK Ansys doesn't like that.
I also assume you made sure that there's enough hard drive space? Have you tried another path / set a different directory as your working directory? |
|
July 24, 2017, 00:08 |
|
#3 |
New Member
jongbeom seo
Join Date: Jul 2015
Posts: 4
Rep Power: 10 |
Thank you Maxim
there is no uncommon letter in the path. path is written with english only. In addition, hard disk space is enough. Actually, I have not tried to solve in another directory. Because It is almost solved by using "essential ouput" in Output control. It is working with 100 iteration case but case with target iteration is still problem. I think it might be related with RAM(I wrote that our cluster has 64G RAM. But I was confused. It is 32G RAM) If you have another idea for this, please let me know |
|
July 24, 2017, 02:12 |
|
#4 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
Then I am out of ideas. You might have to contact Ansys support
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
UDF - Write data into file at the end of every time-step | rookiecfd | Fluent UDF and Scheme Programming | 7 | April 17, 2017 11:21 |
Transient boundary conditions | Jarrod Sinclair (Sinclair) | OpenFOAM Running, Solving & CFD | 133 | May 6, 2015 06:21 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
Unable to write case and data...! | sushii | FLUENT | 4 | December 7, 2007 01:12 |