|
[Sponsors] |
September 18, 2002, 03:57 |
initial value file
|
#1 |
Guest
Posts: n/a
|
Hello All,
I would like to perform a SST calculation in CFX 5.5.1 The idea was to use a k-epsilon calculation and then use the results of the k-epsilon calculation as initial values for the SST calculation in order to help the convergence. Thus I generate the fine mesh with the first node near the wall for the SST calculation and specify this definition file into CFX Solve. Then I add the name of my k-epsilon result file as the initial value file. But the help in the pdf books says that the mesh is then read from from the initial value file, and apparently it's what happens. So how can I proceed to use my fine mesh refined to the wall and the velocity field comimg from the coarse mesh used for the k-epsilon model ? Has anyone a suggestion ? Thank you for your help. Olivier |
|
September 18, 2002, 04:54 |
Re: initial value file
|
#2 |
Guest
Posts: n/a
|
HI Olivier, It sounds as though your two models have different mesh. If this is the case you will need to interpolate the results from the Ke results file onto the SST def file. Then all you need to do is run the SST def file without any initial values file specified. To do the interpolation you will find a little gui in the solver manager under tools. Its very self explanitory. Hope this helps Dave
|
|
September 18, 2002, 23:01 |
Re: initial value file
|
#3 |
Guest
Posts: n/a
|
Did you try starting straight away with the SST model on the fine mesh with a sensible initial guess and no initial results file? The robustness of the SST shouldn't be very different to k-e, so you may not need the initial results file. Mike
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Velocity blows up suddenly after 30,000+ iterations | lordvon | OpenFOAM Running, Solving & CFD | 15 | October 19, 2015 13:52 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
ForcesCoeffs | ronaldo | OpenFOAM | 4 | September 14, 2009 07:11 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |