|
[Sponsors] |
How Can I put inlet condition by the mass flux unit kg/m2 s |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 18, 2017, 05:08 |
How Can I put inlet condition by the mass flux unit kg/m2 s
|
#1 |
New Member
Mohan Kumar Dey
Join Date: Mar 2017
Location: Busan, South Korea
Posts: 8
Rep Power: 9 |
Hello Everyone,
My inquiry is: Is there any option to put the mass flux unit kg/m2 s as a inlet condition in CFX? Thanks for advance. |
|
October 18, 2017, 05:53 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Um, yes. Can I ask that you check the documentation before you ask questions like this in future? A minute reading the documentation would answer this question yourself.
|
|
October 18, 2017, 07:06 |
|
#3 |
New Member
Mohan Kumar Dey
Join Date: Mar 2017
Location: Busan, South Korea
Posts: 8
Rep Power: 9 |
Dear sir,
Yes, I checkd the modeling section in CFX. Here I can see the mass flow rate unit is kg/s, but I want to mass flus kg/m2 s for simulation the liquid to steam phase change by boiling. |
|
October 18, 2017, 07:17 |
|
#4 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
CFX has CEL to handle simple expressions like this. You just say something like MassFlowRate = MassFlux*area()@Inlet.
|
|
October 18, 2017, 07:51 |
|
#5 |
New Member
Mohan Kumar Dey
Join Date: Mar 2017
Location: Busan, South Korea
Posts: 8
Rep Power: 9 |
Thank you sir
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow inlet and pressure outlet with target mass flow rate | Zigainer | FLUENT | 13 | October 26, 2018 05:58 |
Varying mass flow at an inlet boundary condition. Fuel mass flow. | visitor | Fluent UDF and Scheme Programming | 70 | October 30, 2017 16:38 |
setting heat flux inlet boundary condition | eliminator | CFX | 6 | July 28, 2015 08:50 |
Boudaries for bouynat driven flow with additional mass flux at inlet | Charon | CFX | 2 | April 27, 2013 08:02 |
mass flow inlet condition is not properly specified in circulating fluidized bed | abinashlipun | FLUENT | 0 | April 19, 2013 02:28 |