|
[Sponsors] |
May 20, 2003, 11:35 |
Initial Conditions
|
#1 |
Guest
Posts: n/a
|
Hi Guys!, I want to use a solid sub-domain but when I tried to run the solver, appear an error which say : "set initial condition for the solid sub-domain".
Where can I set initial conditions for a solid sub-domain? Carola |
|
May 20, 2003, 14:49 |
Re: Initial Conditions
|
#2 |
Guest
Posts: n/a
|
In the inital conditions form.
|
|
May 21, 2003, 11:29 |
Re: Initial Conditions
|
#3 |
Guest
Posts: n/a
|
Hi Robin!,Iīve been looking for in the Initial Conditions Form, but I couldnīt find any icon which said something about Domains or subdomains. Iīm working with cfx-5.5.1. Could you please help me?
Carola |
|
May 21, 2003, 12:03 |
Re: Initial Conditions
|
#4 |
Guest
Posts: n/a
|
Carola, try the second icon down, going from memory there are 3 at the top. Click on them all and you will find it.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception error | Alan | OpenFOAM Running, Solving & CFD | 11 | July 1, 2021 21:51 |
Error while running rhoPisoFoam.. | nileshjrane | OpenFOAM Running, Solving & CFD | 8 | August 26, 2010 12:50 |
MRFSimpleFoam amp cyclic patches | david | OpenFOAM Running, Solving & CFD | 36 | October 21, 2008 21:55 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
Unknown error | sivakumar | OpenFOAM Pre-Processing | 9 | September 9, 2008 12:53 |