|
[Sponsors] |
February 22, 2018, 02:24 |
Automatic wall Treatment
|
#1 |
New Member
AKS
Join Date: Feb 2012
Posts: 25
Rep Power: 14 |
Hello,
This post is regarding understanding of the boundary conditions for automatic wall treatment in CFX. Suppose, I have two different cases (say wall bounded flow) Case 1. A simulation with Y+ = 1 Case 2. A simulation with Y+ = 30. I wish to run the k-omega model with automatic wall treatment. My Intuitive analysis. For case 1. At the wall. Boundary condition for velocity = No slip k = 0 and Omega= 6*nu/Beta*y^2, here nu is kinematic viscosity. For case 2. Boundary values will be computed from law of the wall. Each parameters (k, omega) will now depend on the friction velocity. Are these expressions use to determine that: k = uT^2/(beta)^0.5 omega = uT/ (beta)^0.5*kappa*y Can somebody put light on these boundary conditions ? thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
OpenFOAM wall function treatment | kimotbwb | OpenFOAM Programming & Development | 7 | March 6, 2015 12:52 |
On the LES near wall treatment | huangxianbei | FLUENT | 8 | August 27, 2014 11:13 |
LES wall treatment | Valerio | FLUENT | 0 | April 26, 2008 07:12 |