 |
 |
 |
|
|
|
[Sponsors] | ||||
November 4, 2003, 18:24
|
Create Thin Surface in Mesh2CAD
|
#1 |
|
Guest
Posts: n/a
|
It semms to me that Mesh2CAD is very friendly. I created two Bodys with one contained the other completely. Then I created several surface parts which are outer faces of the contained Body. When I imported the meshes into CFX-Pre, the surface parts become the only 2D-region for the contained Body. In other words, I can not assign any boundary condition seperatedly to the surfaces of the contained Body. So anybody can give me some hints?
Thanks, Jeniffer |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 10:03 |
| [ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 02:10 |
| Ploting pressure in a thin surface | Pedro Lopes | CFX | 0 | March 25, 2007 15:05 |
| create new surface | subhash | Siemens | 2 | July 30, 2002 04:53 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
