Home > Forums > Software User Forums > ANSYS > CFX

sliding mesh problem

Mark Forums Read

Reply

Search this Thread

December 25, 2003, 10:44	sliding mesh problem	#1
Devin Guest Posts: n/a	hi,all~~ I'm runing a sliding mesh case, but I encounter a problem. On the interface between moving part and stationary part, the distribution of the temperature does not look like continuous. Is there any good way to improve it? Thanks! Devin

January 4, 2004, 17:12	Re: sliding mesh problem	#2
Glenn Horrocks Guest Posts: n/a	Hi Devin, Which code are you using? Are you sure your grid is fine enough? Are you sure your simulation has converged? Glenn

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
CFX Mesh Deformation problem	Silmaril	CFX	7	October 19, 2010 10:00
Sliding Mesh Problem	CC	FLUENT	1	February 8, 2009 23:26
Sliding mesh problem	Michel	FLUENT	1	January 15, 2009 10:18
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

All times are GMT -4. The time now is 18:23.