|
[Sponsors] |
May 5, 2004, 11:51 |
a question in ICEM
|
#1 |
Guest
Posts: n/a
|
I want to simulate a centrifugal pump,whose inlet is a cylinder pipe.I only need to simulate one channel,so the inlet should be a 60-degree-sector region (I have six blades),I do not know how to make grids in this region,because it only has three edges at one section,who can tell me?
thank you |
|
May 5, 2004, 18:18 |
Re: a question in ICEM
|
#2 |
Guest
Posts: n/a
|
use O-grid to make the grid in pipe region so that it will not create the wedges at the center.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] Node Number vs. Node_ID & ICEM vs. CFX | Araz | ANSYS Meshing & Geometry | 1 | April 25, 2011 11:03 |
question on ICEM CFD Tetra | peiyong wang | CFX | 2 | September 3, 2008 18:35 |
ICEM CFD 11 Question | Raj | CFX | 2 | June 25, 2008 02:11 |
ICEM -CFX a basic question | Al Mazdeh | CFX | 2 | April 5, 2008 11:51 |