|
[Sponsors] |
May 17, 2004, 13:49 |
variable source on the interface
|
#1 |
Guest
Posts: n/a
|
I am doing a fuel cell modeling by cfx 5.6. The mass source term at the each point should depend on the concentration of components at the corresponding point of the interface. The components will be consumed along the flow channel, so the source should also decline along the flow direction.
My question is how to express this variable source depending on I(X,Y) or concentration C(X,Y). For example: source term SH2=-1.[ kg kmol^-1 ]/F*Ia*100.[ mm^-1 ] Or total source term SH2=-1.[ kg kmol^-1 ]/F*areaInt(Ia)@catalystlayer But I think that here I only introduce the volumtric averge source on the interface, how to correct it? Expression Ia=I0a*(H2.molconc /conH2ref)^0.5*rate 100.[ mm^-1 ] represent the specific volume (i.e. the thickness of catalyst layer, which can be seen as a 2-D interface) Thank you for your help. Regards, Yi Zhang |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
error in COMSOL:'ERROR:6164 Duplicate Variable' | bhushas | COMSOL | 1 | May 30, 2008 05:35 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 02:24 |
masse source at the interface in VOF model | Marco | FLUENT | 0 | September 26, 2007 06:53 |
how to set velocity in certain place in CFX5 | cfxbeginer | CFX | 6 | July 7, 2003 19:38 |
UDF Scalar Code: HT 1 | Greg Perkins | FLUENT | 8 | October 20, 2000 13:40 |