|
[Sponsors] |
November 26, 2004, 11:00 |
Transient Results
|
#1 |
Guest
Posts: n/a
|
Hello All, I need some explanation on obtaining transient results fron CFX5. I had completed a transient simulation and tried to export it to fieldview, but to my astonishment only the last state was present. Should I have requested a minimal result at some time interval with defined variables ? or full ? I will appreciate if some one can help to understand how to obtain a comprehensive result over the entire time period.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time averaging results from a transient run | Flow Squad | CFX | 4 | October 24, 2011 09:11 |
transient simulation of a rotating rectangle | icesniffer | CFX | 1 | August 8, 2009 07:25 |
Combining Transient results after a backup | Dre | CFX | 9 | February 18, 2008 08:43 |
intermediate results during a transient run | Michael Skoblin | CFX | 1 | September 25, 2006 14:00 |
Minimal transient result lokks like full in Post | Korsh Mik | CFX | 14 | July 19, 2005 02:45 |