|
[Sponsors] |
April 30, 2005, 01:50 |
problem in import ANSYS mesh
|
#1 |
Guest
Posts: n/a
|
I am trying to import an meshed model created in ANSYS to CFX. but after import, it losts its 2D areas and turns out to be a whole block. How can I creat bondary condition with that? The 'HELP' of CFX-pre says: 'to import 2D and 3D region into CFX, each region must be defined with CMBLOCK commands when they are created in ANSYS' But I can not find such a command in ANSYS. I tried CM command to creat areas, but it doesn't work! Does anyone know how to solve this problem? Thank you very much!
|
|
April 30, 2005, 09:17 |
Re: problem in import ANSYS mesh
|
#2 |
Guest
Posts: n/a
|
Use component(CM) one's again, but NODES.
|
|
April 30, 2005, 21:30 |
Re: problem in import ANSYS mesh
|
#3 |
Guest
Posts: n/a
|
Hi, it works! Thank you very much!!!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Workbench mesh crashes (ANSYSWBU.exe problem) | kondan | ANSYS | 76 | February 22, 2024 02:27 |
[Other] engineFoam new mesh problem | ayhan515 | OpenFOAM Meshing & Mesh Conversion | 5 | August 10, 2015 08:45 |
Import ANSYS CFX Mesh to Fluent | Noureddine | FLUENT | 6 | February 11, 2009 12:33 |
Problem on mesh import to Ansys CFX 10.0 | Stephen Lau | CFX | 1 | April 18, 2007 03:02 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |