[Mu_CFD]

Hi everybody,

I've been working in a study of a venturi scrubber with a multiphase steady state flow composed of air (continuous fluid) and water (particle transport fluid). In total, there are 100 particles (droplets of water). The particle aoupling used is Fully Coupled.

The idea was to divide the geometry due to hardware limitations (it is simulating an industril equipment so that it's a big domain. So far I could export the air velocity profile from outlet1 and use it as boundary condition at inlet2 (File>Export>Type BC Profile>Location INLET1> Profile Type Inlet direction).

part1.jpg

I've also exported the whole particle track from the first simulation and see it in the second one (File> Export > Type BC Profile> Location Particle Track 1> Profile Type Inlet diretion) but I coldn't use it as boundary conditions
.
part2.jpg

The idea is to see the particles track also in second simulation but so far I wasn't able to. Could some one help me? It would be very helpfull in developing my study.

Any questions that you may have, be my guest.

Thank you a lot.