CFD Online Logo CFD Online URL
Home > Forums > CFX

How to properly use the Virtual Topology?

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   September 22, 2005, 00:16
Default How to properly use the Virtual Topology?
Posts: n/a
Hello to everyone! Could somebody who successfully used Virtual Topology (VT), advise please:

Once I created a VT face, it says it cannot merge the areas, but does not say which ones. I examine the auto-created VT edges, and do not like them, as they are only a part of actual edges between a newly created VT face and other faces or betwee neighbouring VT faces. Also some of them are locked. DO not know if it is OK or wrong.

Rather than VT faces, should I create VT edges first? What is your algoythm of using VT, please?

Thank you

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Virtual Topology and "Project to underlying geometry" antonio ANSYS Meshing & Geometry 2 May 22, 2015 14:41
Could you please help me about the VTKFoam liugx212 OpenFOAM Pre-Processing 5 February 13, 2008 12:31
OpenFoam 14 installation problem gfcoppola OpenFOAM Installation 20 November 2, 2007 14:38
Could you please help me liugx212 OpenFOAM Paraview & paraFoam 4 December 22, 2005 17:55
LibvtkFoamso fred OpenFOAM Paraview & paraFoam 2 November 18, 2005 20:01

All times are GMT -4. The time now is 17:26.