 |
 |
 |
|
|
|
[Sponsors] | ||||
October 24, 2005, 00:19
|
baffle in flow route
|
#1 |
|
Guest
Posts: n/a
|
How can I make a volume mesh for an empty box which contains a thin baffle? This baffle was set at the center of this empty box. I have assign each parts e.g. pts, curves and surfaces including the baffle for my model and given them max mesh size. When meshing complete and transferring into CFX, I can not see the "baffle" part under the tree of assembly. But when I use scan-plane in ICEMCFD, I can be sure that nodes and vertices have been located on the baffle.
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Flow meter Design | CD adapco Group Marketing | Siemens | 3 | June 21, 2011 09:33 |
| What is the difference between liquid reactive flow and gas reactive flow? | James | Main CFD Forum | 6 | May 15, 2009 13:14 |
| potential flow vs. Euler flow | curious ... | Main CFD Forum | 23 | July 21, 2006 08:40 |
| Plug Flow | Franck | Main CFD Forum | 3 | September 4, 2003 06:57 |
Linear Mode
