|
[Sponsors] |
March 21, 2006, 12:03 |
Material Table
|
#1 |
Guest
Posts: n/a
|
Hi friends,
I am trying to give viscosity data which depends on temperature as a table. I have 10 data points to give. However I could not figure out how to do it. I am using CFX-10, but I dont think version is important. thanks in advance |
|
March 21, 2006, 14:03 |
Re: Material Table
|
#2 |
Guest
Posts: n/a
|
Dear Mgtripple,
Create a User Function 1D interpolation function, and later set the value of viscosity to that function. Search documentation for User Function Editor.. Good luck, Opaque |
|
April 28, 2006, 10:44 |
Re: Material Table
|
#3 |
Guest
Posts: n/a
|
Hi, Do you know what is the viscosity range for Marble or Limestone in normal temperature ? Thanks in advence Behnam
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Wall Material | Maple | FLUENT | 4 | March 13, 2009 05:39 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
material mass imbalance | Im | FLUENT | 3 | September 5, 2001 22:47 |