|
[Sponsors] |
August 30, 2006, 04:07 |
Additional Varialbes at the OPENING boundary
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I am modeling a multiphase system, in which I need to introduce two Additional Varialbes (AV) for each phase (water & Air) which they would be considered as oxygen concentration in each phase... Problem: I have an opening boundary condition at the top of my model at which, the water is freely going in/out, (of course the same water of the domain). this means that I need to set the (AV)s at the OPENING boundary in a way that no new water comes in (but the same water contating the specitic oxygen concentration shall only enter the domain...) and it's a transient settings model. Would highly appreciate any help/comments... Houman |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 05:58 |
emag beta feature: charge density | charlotte | CFX | 4 | March 22, 2011 09:14 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 01:54 |