|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Good afternoon, it is necessary to simulate work of a rotating furnace thus it is necessary to satisfy following conditions: to set an inclination of the furnace 2 hailstones.; the atomizer is located on the separate base, accordingly under a corner to an axis of the furnace; the furnace has the set speed of rotation. Prompt as to set these conditions? And whether it is necessary at calculation of a grid contact of geometry of an atomizer and the furnace?
Thank you Alexander A. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
||
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modeling of furnace in Gambit | Abba H | FLUENT | 7 | December 6, 2011 11:59 |
Furnace curtains | Marc | FLUENT | 0 | April 18, 2007 08:01 |
Furnace Combustion wall problem | Leigh | FLUENT | 2 | December 11, 2006 15:01 |
Furnace wall heat exchange | Andrea | FLUENT | 8 | November 11, 2005 03:37 |
gas-fired furnace modelling | Alexis Devenin V. | Main CFD Forum | 0 | December 3, 2002 11:45 |