|
[Sponsors] |
January 25, 2007, 05:44 |
2D Simulations
|
#1 |
Guest
Posts: n/a
|
Hallo everybody!
Does anyone know how to create a 2D (quasi) simulation in CFX10? The help file says it's possible, but following those steps I always get a message: "CFX can only operate on Solid Volumes!". I want to create a simple planar rectangular surface with one moving boundary, no inlets and outlets and simulate gas behaviour bounded by the geometry. Thanks a lot for any replies! Greetings, Uros. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Periodic boundary conditions in 3D Eulerian granular flow simulations | dsm | FLUENT | 4 | March 2, 2012 19:04 |
Hardware selection for steady/unsteady incompressible, turbulent and cht simulations | maddalena | OpenFOAM | 2 | July 13, 2011 08:55 |
Cumulative continuity error large in parallel simulations | xiao | OpenFOAM | 3 | March 7, 2011 04:13 |
Timestepping in two - phase Simulations using RSM | challenger85 | CFX | 0 | January 4, 2010 05:00 |
URANS and Transient Simulations | bob | Main CFD Forum | 0 | October 1, 2003 03:54 |