Geometry Error in TURBOGRID

Gokkul · February 21, 2022, 10:37

Hello everyone

Hope you all are doing well!

I am quite new to the simulation regarding the Turbomachines. Right now, I am simulating a 2-stage turbine. I have the co-ordinates for hub, shroud, blade profile. I tried to import the file to Turbogrid but I am getting an error stating that "Start and end parametric value are identical". I tried searching for solution but unfortunately couldn't solve it. It would be great if you could assist me in this issue.

Thanks in advance.

Stel · February 22, 2022, 07:27

Not the right forum for that but anyway, could you post the hub and shroud curves so we can inspect them?

Gokkul · February 22, 2022, 10:20

Hello Stel

Thanks for the response. I was able to figure out the mistake I made. I selected the principal axis as "Z" instead of "X". Now I am able to import the geometry.

February 21, 2022, 10:37	Geometry Error in TURBOGRID	#1
Gokkul New Member Gokkul Raj Join Date: Sep 2019 Location: Berlin Posts: 11 Rep Power: 8	Hello everyone Hope you all are doing well! I am quite new to the simulation regarding the Turbomachines. Right now, I am simulating a 2-stage turbine. I have the co-ordinates for hub, shroud, blade profile. I tried to import the file to Turbogrid but I am getting an error stating that "Start and end parametric value are identical". I tried searching for solution but unfortunately couldn't solve it. It would be great if you could assist me in this issue. Thanks in advance.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] CATIA Geometry Generation and Meshing	danielsullivan	ANSYS Meshing & Geometry	0	April 3, 2017 22:11
Fill CAD Geometry	voldemort	Autodesk Simulation CFD	0	July 12, 2016 02:47
Import Deformed Geometry into Fluent	lgamble	FLUENT	1	February 25, 2016 14:59
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
[ANSYS Meshing] TurboGrid export geometry after meshing	la7low	ANSYS Meshing & Geometry	0	January 13, 2011 20:50

February 22, 2022, 07:27		#2
Stel Member Henrique Stel Join Date: Apr 2009 Location: Curitiba, Brazil Posts: 93 Rep Power: 18	Not the right forum for that but anyway, could you post the hub and shroud curves so we can inspect them?

February 22, 2022, 10:20		#3
Gokkul New Member Gokkul Raj Join Date: Sep 2019 Location: Berlin Posts: 11 Rep Power: 8	Hello Stel Thanks for the response. I was able to figure out the mistake I made. I selected the principal axis as "Z" instead of "X". Now I am able to import the geometry.