|
[Sponsors] |
July 7, 2007, 09:02 |
Negative volume in mesh motion
|
#1 |
Guest
Posts: n/a
|
Dear Friends
I was solving a moving mesh problem like check valve.y negative volume occurs reason? ERROR #002100012 has occurred in subroutine cVolSec. Message: A negative ELEMENT volume has been detected. This is a fatal error and execution will be terminated. The location of the first negative volume is reported below. Volume : -0.4107E-13 | Location : ( -0.35156E-02, 0.36065E-01, -0.49511E-03) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Dynamic mesh, negative volume, help! | vboris | FLUENT | 0 | February 23, 2011 17:19 |
engrid: Internal volume mesh becoming coarser during boundayr layer addition | Arnoldinho | OpenFOAM | 1 | January 22, 2011 04:31 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |