CFD Online Logo CFD Online URL
Home > Forums > CFX

Overflow error

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   September 5, 2007, 05:36
Default Overflow error
Posts: n/a
Now, I simulated the 2D reactor. I used CFX mesh with extrusion.Time step that was used is about 1e-6. The turbulent model k-e.I tried to use fine mesh and small of time step but the simulation still not converge. What should I do ?
  Reply With Quote

Old   September 5, 2007, 18:33
Default Re: Overflow error
Glenn Horrocks
Posts: n/a
Look Here and read the documentation.

Glenn Horrocks
  Reply With Quote

Old   September 6, 2007, 22:01
Default Re: Overflow error
Posts: n/a
Thank you very much for your suggestion.

I did following the suggestion but the simulation did not converge. I reduced the blend factor that was used below 0.75. I try to vary the timestepping around 1e-5 - 1e-7.

The simulation was set in isothermal and it was simulated with two phases(gas-solid). Air 25 C and solid particles represent gas and solid phases, respectively. Moreover, Kinetic theory was added in the model.

I want to know more about the limit of using kinetic theory in CFX.

Thank very much.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Compile calcMassFlowC aurore OpenFOAM Programming & Development 12 March 18, 2014 05:22
nonNewtonian viscosity model mhassani OpenFOAM Programming & Development 5 January 7, 2013 10:27
Accessing phi from a fvPatchField at same patch johndeas OpenFOAM 1 September 13, 2010 20:23
attach/detach (valve opening/closing) phsieh2005 OpenFOAM Running, Solving & CFD 2 March 21, 2009 06:18
OpenFOAM on MinGW crosscompiler hosted on Linux allenzhao OpenFOAM Installation 127 January 30, 2009 20:08

All times are GMT -4. The time now is 06:16.