|
[Sponsors] |
ICEM CFD-- ic engine combustion chamber meshing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 12, 2007, 05:53 |
ICEM CFD-- ic engine combustion chamber meshing
|
#1 |
Guest
Posts: n/a
|
hi, its been a 3 months i'm trying to mesh the bowl in piston combustion chamber of ic engine.. the geometry consists of inlet valve, cylinder wall and offset piston bowl and.. its a moving and deforming mesh problem. the clearance volume between cylinder head and piston is 1.5 mm and it can also be increased till 5mm.i got the initial mesh but it is having very less quality ( 4 percent and orthogonality angle of 1.2 deg.) so, can u plz tell me if its possible to have good quality mesh for this geometry in ICEM CFD or is there any other approch to mesh it. i want the mesh to deform from top dead center to bottom dead center i.e. from clearnce volume of 1.5mm to 117.5 mm. i'll very grateful for your suggestion.. thank u be happy regards chetan M.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Having several dificulties with 3d airfoil meshing in ICEM CFD | Teja | ANSYS Meshing & Geometry | 14 | February 23, 2015 13:01 |
Wind tunnel hexa meshing in ICEM CFD 12.1 | matheusguzella | ANSYS Meshing & Geometry | 1 | March 14, 2011 16:14 |
Icem CFD Meshing Problem | eRzBeNgEl | ANSYS | 1 | January 20, 2011 07:55 |
pipe flow- meshing in ICEM CFD? | Nikhil | CFX | 2 | February 29, 2008 06:14 |
ICEM CFD 2D meshing guide for CFX (1cell height) | Korsh Mik | CFX | 1 | October 27, 2005 22:45 |