 |
 |
 |
|
|
|
[Sponsors] | ||||
December 10, 2007, 03:23
|
Reaction Initiation using EDM
|
#1 |
|
Guest
Posts: n/a
|
Dear all,
I just started to simulate simple coaxial non-premixed jet combustion inside cylindrical furnace. I have problems to initiate the reaction using EDM. Where can I input the ignition? Thank you. |
|
|
||
|
December 12, 2007, 20:48
|
Re: Reaction Initiation using EDM
|
#2 |
|
Guest
Posts: n/a
|
I found out from the manual, just set some portions of combustion product gases (CO2, H2O) at the inlet gas composition. Hope it is useful.
Thank you. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Segmentation fault in running alternateSteadyReactingFoam,why? | NewKid | OpenFOAM | 18 | January 20, 2011 16:55 |
| reaction in UDF(DEFINE_VR_RATE) | louiza | FLUENT | 3 | October 13, 2010 23:59 |
| CFX5.7 - chemical reaction problem... | H.L. | CFX | 4 | March 25, 2009 10:33 |
| chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 00:07 |
| chemical reaction - howto | Dan Sorensen | Siemens | 1 | February 21, 2000 09:20 |
Linear Mode
