 |
 |
 |
|
|
|
[Sponsors] | ||||
January 23, 2008, 12:37
|
Solver crashing with error
|
#1 |
|
Guest
Posts: n/a
|
My solver carshes with following error:
Error in subroutine get_COURANT : Error calculating Courant Number GETVAR originally called by subroutine UPD_DVAR_ZONE How can i diagnose it. Thanks Usman |
|
|
||
|
January 23, 2008, 23:57
|
Re: Solver crashing with error
|
#2 |
|
Guest
Posts: n/a
|
Well, I think there is a problem during your preprocessing. Do you mind to tell me what are you doing so I can try to identify the problem?
|
|
|
|
||
|
January 24, 2008, 06:59
|
Re: Solver crashing with error
|
#3 |
|
Guest
Posts: n/a
|
Hi Jack
I am simulating a flow on duct with ribs inside. I was trying to disable the old statistics by setting up new iterations when it started to crash. However, it is working fine for now. I think it is due to fact that i was setting up my stop itheration number too high. Thanks for your reply. Usman |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
| How to install CGNS under windows xp? | lzgwhy | Main CFD Forum | 1 | January 11, 2011 18:44 |
| ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 06:42 |
| Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 20:23 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
Linear Mode
