Home > Forums > Software User Forums > ANSYS > CFX

element size control in ICEM (line & face spacing)

Mark Forums Read

Reply

Search this Thread

January 28, 2008, 14:28	element size control in ICEM (line & face spacing)	#1
Sam Guest Posts: n/a	Hi, How can we specify an 'element size control' around a line/face in ICEM-TETRA? I am talking about the same effect as that of 'face spacing' and 'line spacing' in CFX-Mesh or 'size function' in Gambit. I guess 'create density' in ICEM should work as 'point control' but how to create line or face spacing control in ICEM? Please help. Regards, Sam

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
blockMesh error ...	balkrishna	OpenFOAM Pre-Processing	0	August 17, 2010 03:39
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15
Problems of Duns Codes!	Martin J	Main CFD Forum	8	August 15, 2003 00:19
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 16:16

All times are GMT -4. The time now is 00:00.