Importing Ansys .cdb mesh and geometry into CFX 11

February 18, 2008, 11:48

Hi,

I am trying to import a geometry and mesh (created in ProE and meshed in Ansys) .cdb file into CFX Pre. When the mesh is imported, parts of it are highlighted in green, and I am unable to define "primitive regions" correctly to apply boundary conditions (eg it will select the edge of the inlet surface/are rather than the whole area)

Any Ideas?

Thanks

February 18, 2008, 12:08

The problem is that the automatically generated "primitive 2Dregion" only seems to cover some parts of the exterior surface, rather than all of it.

February 18, 2008, 11:48	Importing Ansys .cdb mesh and geometry into CFX 11	#1
Tom Guest Posts: n/a	Hi, I am trying to import a geometry and mesh (created in ProE and meshed in Ansys) .cdb file into CFX Pre. When the mesh is imported, parts of it are highlighted in green, and I am unable to define "primitive regions" correctly to apply boundary conditions (eg it will select the edge of the inlet surface/are rather than the whole area) Any Ideas? Thanks

February 18, 2008, 12:08	Re: Importing Ansys .cdb mesh and geometry into CF	#2
Tom Guest Posts: n/a	The problem is that the automatically generated "primitive 2Dregion" only seems to cover some parts of the exterior surface, rather than all of it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit problems	Althea	FLUENT	22	January 4, 2017 04:19
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
Problem importing GAMBIT mesh to Ansys geometry	David G.	CFX	0	June 19, 2005 07:01