CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

help on mass sink using CEL function

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   March 19, 2008, 00:57
Default help on mass sink using CEL function
  #1
buhkuh
Guest
 
Posts: n/a
Hello CFX experts,

I want to set a sink(mass flux) for the walls using the equation: flux=rho(const)*void*velocity. But I want to use the values of void and velocity at a certain point below the wall (e.g. 2mm below the wall). I'm not sure if USER_GETVAR can get it since it's away from the wall, but if yes how would I get those values at my desired points? I did something before but in a different way, I used monitor/source pts in PRE and send the void and vel values at those points to fortran using the CEL function. But it's very limited since I have to make so many points. I want to do it in a general way. Hope you have some insights about this.

Thanks a lot guys! Ariel
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
LiencubiclowRemodel nzy102 OpenFOAM Bugs 14 January 10, 2012 09:53
[blockMesh] BlockMesh FOAM warning gaottino OpenFOAM Meshing & Mesh Conversion 7 July 19, 2010 15:11
Version 15 on Mac OS X gschaider OpenFOAM Installation 113 December 2, 2009 11:23
OpenFoam 14 installation problem gfcoppola OpenFOAM Installation 20 November 2, 2007 14:38
Mass fraction via Cel file at outlet Jens CFX 3 April 28, 2003 10:14


All times are GMT -4. The time now is 12:32.