|
[Sponsors] |
May 19, 2008, 11:38 |
ICEM export - Ansys Import Problem
|
#1 |
Guest
Posts: n/a
|
hey again!
my model is in 2D -> my mesh is 2D to export my mesh in CFX, I have to extrude my whole mesh for 1 layer. then I can "write input-file" for cfx5. the problem is, that ansys cfx doesnt load my mesh. it just says " had problems to load mesh - Problem: unknown" someone got similar problems or had this kind of message? I'm stuck here for several hours and I dont f... know why! thx! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Import Mesh from ICEM CFD to CFX | Andre Almeida | CFX | 16 | April 19, 2016 04:42 |
Import transient cfx-results for static structural analysis in Ansys WB 13 | Colt Seavers | ANSYS | 1 | August 11, 2011 07:01 |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 21:03 |
problem exporting from icem to fluent | jc_muaddib | FLUENT | 1 | June 16, 2010 05:16 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 21:30 |