 |
 |
 |
|
|
|
[Sponsors] | ||||
February 21, 2011, 10:57
|
Multiple probe points
|
#1 |
|
New Member
Øyvind Larsen
Join Date: Feb 2011
Posts: 2
Rep Power: 0  |
Hi! I`m relative new to Ansys CFX and hope someone can answer my question.
I made a mesh in TurboGrid of an centrifugal compressor, and simulates this in CFX... works fine... but I want to insert 5 points through the blade passage at some coordinates/selected points and extract the values for pressure at these points so I can compare them to experimental results. I want these points to be constant so that I can run different simulations with for example varying volume flow, and read out pressure difference at these 5 points. Thanks! |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh - no layer added | bejbro | OpenFOAM Meshing & Mesh Conversion | 5 | February 1, 2020 20:05 |
| Using Probe for part of a patch | ndr | OpenFOAM Running, Solving & CFD | 7 | April 4, 2019 06:26 |
| OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 12:21 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
| ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 16:29 |
Threaded Mode
