 |
 |
 |
|
|
|
[Sponsors] | ||||
March 15, 2011, 22:56
|
interpolate - previous result file in DP
|
#1 |
|
New Member
Join Date: Nov 2010
Posts: 26
Rep Power: 15  |
i'm simulating turbocharger's turbine side and RPM is 195k.
i couldn't get the convergenece at 195k RPM so 1st with 10k and slowly i'm increasing the rpm. so i've created a parameter set in workbench. design point 1- RPM: 10000 mass flow:xxx design point 2 - RPM: 50000 mass flow:yyy like that i've created a 6 design ponts and solved the problem. for DP2 solver take DP1's results - it's ok but for DP3 it take DP1's result file. hope understood my problem, now... How can i change these setting? thank you |
|
|
|
|
|
March 18, 2011, 06:16
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Change what settings?
|
|
|
|
|
|
|
March 18, 2011, 06:20
|
|
#3 |
|
New Member
Join Date: Nov 2010
Posts: 26
Rep Power: 15 |
assigning previous run's result file.
automatically in workbench |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.com] OpenFOAM 1.7.1 installation on LINUX UBUNTU 10.10 | electrosin | OpenFOAM Installation | 40 | May 31, 2016 05:11 |
| Working directory via command line | Luiz | CFX | 4 | March 6, 2011 20:02 |
| paraview installation woes | vex | OpenFOAM Installation | 15 | January 30, 2011 07:11 |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
| Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 06:43 |
Linear Mode
