|February 21, 2012, 01:06||
Hypermesh and CFX
Join Date: Feb 2012
Posts: 2Rep Power: 0
I am having some problems importing a 3d-mesh (CFD) from Hypermesh v10 in Ansys CFX v13 or Workbench v13.
Is this possible?
I created the mesh using Ansys User Profile in Hypermesh.
the error message in CFX is always the following:
"ERROR There was a problem importing the mesh from the requested file.
The importing process reported the following problem:
Unable to import mesh: No 3D elements imported."
used Filetypes: *.nas, *.cdb, *.cas
Thanks in advance!
|February 21, 2012, 17:10||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 13,209Rep Power: 103
I have no idea about hypermesh but your problem is CFX cannot read the mesh. Obviously an import/export problem. I suspect that the ANSYS user profile in hypermesh actually generates an ANSYS FEA mesh. So you can read that into ANSYS FEA and then pipe it into CFX.
|October 10, 2012, 01:54||
Abdul Afoo Parkar
Join Date: Oct 2012
Posts: 42Rep Power: 6
I have had quite a bit of experience with HyperMesh. I did not have to get into exporting etc. because I was focused on one of their application-specific Eulerian solvers (HyperXtrude).
After reading your post, I am curious whether you finally solved your problem. If so, what was the solution?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Hypermesh to cfx||XTYY||CFX||0||July 24, 2009 06:42|
|Urgent Problem with Hypermesh and CFX||Luk||CFX||5||March 14, 2008 05:59|
|Hypermesh Export||Kieran Hood||CFX||1||February 7, 2007 18:45|
|hypermesh and CFX||garywang||CFX||2||April 24, 2005 20:20|
|how about Hypermesh software||Kulasekharan||FLUENT||4||October 15, 2004 11:51|