|
[Sponsors] |
April 14, 2010, 22:26 |
Mesh Independence Question
|
#1 |
New Member
MT
Join Date: Mar 2010
Location: USA
Posts: 20
Rep Power: 16 |
I am currently using COMSOL Muliphysics to solve some fluid-thermal problems and am currently doing a mesh independence study. Because of the limitations of my computer i can only perform the calculations to a certain point before I eat up all my ram. I heard about a technique a while back when I could project the error further. Is there a way to do this and are there any good references?
Thanks MT |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
ICEM 2D tetra mesh question | kawamatt2 | ANSYS Meshing & Geometry | 18 | March 3, 2014 10:56 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
Mesh independence study and Wall Y+ | sam | Main CFD Forum | 3 | September 15, 2006 08:17 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |