|
[Sponsors] |
October 27, 2022, 05:34 |
multi-fuel setup in SAGE combustion model
|
#1 |
New Member
shanghua chen
Join Date: May 2018
Posts: 29
Rep Power: 7 |
Hi all,
I am confused when I setup my case with dual fuel. In order to simulate RON92 condition, I set IC8H18 as 92% and C7H16 as 8%. Both fuel are well blended and flowed into cylinder as premixed condition. However, from the combustion model, there is only one fuel species available for selection, shown as attached figure. So my question is: should I stick to default setting or switch to other combustion model? If you have any similar experience, please let me know. Thank you. |
|
October 28, 2022, 10:06 |
|
#2 |
New Member
LLI
Join Date: Sep 2022
Posts: 6
Rep Power: 3 |
Hi Shanghua
For the current combustion model (SAGE detailed chemical kinetics model), the species name here is not important for the simulation, you can select any species in your mech.dat file to pass the setup check. So you can use SAGE model and put IC8H18 there for species name, and do not need to switch to other combustion model. Sincerely Lu |
|
October 30, 2022, 20:01 |
|
#3 | |
New Member
shanghua chen
Join Date: May 2018
Posts: 29
Rep Power: 7 |
Thank you very much.
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
eddy dissipation model: combustion doesn't occur | roukaia | FLUENT | 2 | November 18, 2020 10:23 |
Detailed Chemical reaction over combustion model | jaychhatbar | AVL FIRE | 1 | June 23, 2017 13:13 |
Problem on EDC model for coal combustion | lei | FLUENT | 4 | September 3, 2015 09:39 |
Problems with liquid fuel combustion | santhosh1987 | FLUENT | 0 | January 20, 2012 05:13 |
multi fluid mixture model issue | rystokes | CFX | 3 | August 9, 2009 19:13 |