|
[Sponsors] |
May 6, 2017, 17:09 |
Volume data in .col file
|
#1 |
New Member
Nitisha Ahuja
Join Date: Mar 2017
Posts: 14
Rep Power: 9 |
Hello,
I am trying to get local cell film height data from .col file for spray wall impingement simulation. Volume data in the .col file has zero value even if the cell film height is non zero. I am not able to understand why. Thanks Nitisha |
|
May 10, 2017, 15:33 |
|
#2 |
New Member
Chaitanya Ghodke
Join Date: May 2017
Location: Convergent Science, Madison WI
Posts: 29
Rep Power: 8 |
Nitisha,
How do you know that the film thickness is non-zero at those locations? Could you please let me know.
__________________
--------------------------------------------- Chaitanya D. Ghodke, Ph.D. Senior Research engineer Convergent Science Inc. --------------------------------------------- |
|
May 10, 2017, 16:02 |
|
#3 |
New Member
Nitisha Ahuja
Join Date: Mar 2017
Posts: 14
Rep Power: 9 |
In the simulation I used O'rourke & Amsden wall film model, where I can get local cell film height as an output if I declare film height as an output in post.in. I converted the output files to the.col and .par format. The .col format gives me boundary cell locations, volume,mass and film ht at the cell location. But the problem is in many cell locations the film height is greater than zero but the volume is zero.
Since at a particular cell location if film height is greater than zero, the volume should also exist, which is not the case in my output file. Please let me know why is it so. Thanks Nitisha |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Custom Thermophysical Properties | wsmith02 | OpenFOAM | 4 | June 1, 2023 14:30 |
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
[swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |