|
[Sponsors] |
November 2, 2017, 12:28 |
How to find wall heat transfer
|
#1 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Hello,
I'm simulating dual-fuel engine. How can I get the wall heat transfer output file? In Output file, there is heat transfer output which is ''no output'' by default. What does it mean ''General local heat transfer data'' or '' General custom heat transfer data''? Amin. |
|
November 7, 2017, 16:30 |
|
#2 |
Member
Tristan Burton
Join Date: Sep 2017
Posts: 92
Rep Power: 8 |
Amin,
In CONVERGE Studio under the Output files section, you can turn on Heat transfer output e.g. write transfer.out file with wall heat transfer data for each cell adjacent to a wall boundary at output frequency twrite_transfer. The use of a transfer.in (Generate custom heat transfer data) file will allow you to restrict output to specific boundaries and include some additional output (see the manual for details). Best regards, Tristan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
How to set heat transfer coefficient and wall temperature | jpina | FLUENT | 1 | March 21, 2016 08:47 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
Problem Building OF on Centos cluster (no admin rights) | CKH | OpenFOAM Installation | 5 | November 13, 2011 06:32 |
natural convection | mehrdadeng | CFX | 10 | February 25, 2011 05:25 |