|
[Sponsors] |
October 12, 2017, 16:12 |
CA50 data
|
#1 |
New Member
Sanket
Join Date: Jul 2017
Posts: 20
Rep Power: 8 |
In Engine performance tool its showing "not enough data".
I wants CA50 data from this. My simulation is from IVC(-85 degree) to EVO(+130degree). |
|
October 13, 2017, 15:35 |
|
#2 |
Senior Member
Kislaya Srivastava
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 165
Rep Power: 8 |
Hello Sanket,
To collect the data and determine the bounds for each cycle, CONVERGE STUDIO takes the time at which the piston reaches TDC and uses data from the 180 CAD before and after TDC. You do not have this data, and thus you're being provided with that message. I would suggest to include data from -180 to +180 CAD (at the least) if you intend to make use of the engine performance calculator in STUDIO. Hope this helps. Sincerely, Srivastava |
|
December 8, 2017, 07:31 |
|
#3 | |
Member
Yaopeng Li
Join Date: Dec 2017
Location: Lund, Sweden
Posts: 50
Rep Power: 8 |
Quote:
Hi Srivastava For the same example, if I only add the data at -180 CAD and 180 CAD, will it works? The data will be like: -180 pressure, temperature...... -70 pressure, temperature...... -69 pressure, temperature...... -68 pressure, temperature...... . . . 133 pressure, temperature...... 134 pressure, temperature...... 135 pressure, temperature...... 180 pressure, temperature...... THX. Best wishes, Yaopeng |
||
December 11, 2017, 09:35 |
|
#4 |
Senior Member
Kislaya Srivastava
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 165
Rep Power: 8 |
Hello Yaopeng,
Just to correct myself, you require data 180 CAD before and after firing TDC. If your firing TDC is at 0 CAD, adding points at -180 and +180 should work. Make sure you have values for Pressure, Volume, iHR and HR Rate in your data file. Sincerely, Srivastava |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
[OpenFOAM] Paraview doesn't seem to be picking up data generated by icofoam | MikeHersee | ParaView | 2 | January 6, 2015 08:27 |
Data Produced From Fine Marine Cant Match with The Experimental Data | PeiSan | Fidelity CFD | 4 | August 23, 2014 05:33 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |