 |
 |
 |
|
|
|
[Sponsors] | ||||
April 7, 2018, 02:07
|
Unit of species given in map.out file
|
#1 |
|
New Member
Ankit Raut
Join Date: Sep 2017
Location: Chennai
Posts: 14
Rep Power: 8  |
I am using converge for engine simulation. I have created map.out file. I wanted to know the units of species mentioned in the map file, especially H2O, N2, O2, CO2 etc. Are these in mass fraction or kg?
Link to the map.out file: https://drive.google.com/open?id=1RU...1lF1muIKywi0Pv. Thanks and Regards, Ankit |
|
|
|
|
|
April 11, 2018, 10:23
|
|
#2 |
|
New Member
Dan Maciejewski
Join Date: Apr 2018
Location: Madison, WI, USA
Posts: 11
Rep Power: 8 |
In CONVERGE 2.4 manual, chapter 23 explains the content of every output file, column by column. Please see map_<time>.out entry. This file lists the mass fraction in the column under each gas specie in the simulation.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
| Problem compiling a custom Lagrangian library | brbbhatti | OpenFOAM Programming & Development | 2 | July 7, 2014 11:32 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |
Linear Mode
