Cylinder pressure correct but Heat release rate very high

pradeep6890 · April 30, 2019, 06:02

I modelled a closed cycle diesel combustion in Converge to validate experimental values where I found the pressure to be matching but the heat release rate have double the values. how to reduce the values of HRR?

also is J/time same as J/CA?

thank you in advance

ywang89 · May 8, 2019, 13:11

Quote:

Originally Posted by pradeep6890

I modelled a closed cycle diesel combustion in Converge to validate experimental values where I found the pressure to be matching but the heat release rate have double the values. how to reduce the values of HRR?

also is J/time same as J/CA?

thank you in advance

For engines, the unit of HRR is j/degree. If the pressure can match well with the experiment, HRR should match well too. Can you compare the integrated heat release with the energy that you added based on the fuel mass? If they are very different, you fuel amount may not be accurate.

Thanks,

pradeep6890 · May 10, 2019, 01:42

Thank you very much. I thought of using the pressure values from CONVERGE and obtain HRR by applying 1st law which is quite simple using MATLAB.

April 30, 2019, 06:02	Cylinder pressure correct but Heat release rate very high	#1
pradeep6890 Member Pradeep Join Date: Nov 2014 Posts: 45 Rep Power: 13	I modelled a closed cycle diesel combustion in Converge to validate experimental values where I found the pressure to be matching but the heat release rate have double the values. how to reduce the values of HRR? also is J/time same as J/CA? thank you in advance

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Heat release rate calculation	sanket31594	CONVERGE	1	September 5, 2017 22:33
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 02:27
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 06:15
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 16:00

May 10, 2019, 01:42		#3
pradeep6890 Member Pradeep Join Date: Nov 2014 Posts: 45 Rep Power: 13	Thank you very much. I thought of using the pressure values from CONVERGE and obtain HRR by applying 1st law which is quite simple using MATLAB.