|
[Sponsors] |
Making model sensitive to Wall temperature and creating new parcel through UDF |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 23, 2020, 16:14 |
Making model sensitive to Wall temperature and creating new parcel through UDF
|
#1 |
New Member
Iowa
Join Date: Sep 2019
Posts: 4
Rep Power: 6 |
Hi,
I have stationary cylinder model where only one parcel is injected with spray_breakup_flag turned on. I have been using user_film_splash and user_film_splash_velocity UDF to change the radius expression and splashed velocity expression and found that model is responding to these changes. However, I am not able to generate the new parcel and make the model sensitive to wall temperature when I turn on the UDFs. With these two UDFs, the outcome of one parcel after impingement is only one rebounding parcel. I was wondering if there's a way to modify the UDF to generate more than one parcels after impingement and make the model sensitive to wall temperature.I would really appreciate the help. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating a heat Flux UDF with a temperature Dependent argument | nagas | Fluent UDF and Scheme Programming | 3 | March 20, 2018 07:14 |
Fluent Radiation/porous media | Schmitt pierre-Louis | FLUENT | 26 | September 1, 2016 10:29 |
BrownianMotionForce in "reactingParcelFoam". parcel escaped from inlet and diverged. | bijan darbari | OpenFOAM Running, Solving & CFD | 7 | June 7, 2016 02:47 |
problem with solving lagrange reaction cloud | Polli | OpenFOAM Running, Solving & CFD | 0 | April 30, 2014 07:53 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |