CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > CONVERGE

Error while doing simulation

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 15, 2021, 22:28
Default Error while doing simulation
  #1
New Member
 
tianyuan Xia
Join Date: Apr 2021
Posts: 10
Rep Power: 5
hudehfu is on a distinguished road
Hello everyone :
I'm meeting this error as follows:

0364 WARNING: it = 1, WARNING ... extrapolating on the temperature calculation

JOB ABORT invoked by rank 0:
0366 ERROR: Something is wrong in function get_temp_from_table_massfrac: upper_energy_value must be greater than lower_energy_value!
upper_energy_value is -nan(ind), and lower_energy_value is -nan(ind).

This error will be reported after about two degrees of gasline injection.
Can everyone tell me what caused this error and how to solve it
hudehfu is offline   Reply With Quote

Old   April 19, 2021, 18:30
Default
  #2
Senior Member
 
ksrivast's Avatar
 
Kislaya Srivastava
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 165
Rep Power: 9
ksrivast is on a distinguished road
Hello Tianyuan,

Temperature extrapolation issues can occur to a variety of reasons, like poor grid, too large time-steps, poor initial/boundary conditions, poor solver settings, etc. It would be premature to offer you solutions on how to fix this just by looking at the message. We would require more details about your case setup. But you can start with reducing your time-steps/cfl limits to see if it helps. You mentioned it occurs right after start of injection. You could check to see if your current spray and grid settings lead to too much liquid mass in a single cell. If that turns out to be the case, increase your num_parcels_per_nozzle in spray.in.

If you continue to face issues, please reach out to us at support@convergecfd.com. Please use your official email for all correspondence with Convergent Science. Please mention the issues you're facing, attach your case setup and add the cfd-online thread, as reference.

Sincerely,
__________________
Kislaya Srivastava
Principal Research Engineer | Applications
CONVERGECFD
ksrivast is offline   Reply With Quote

Reply

Tags
error in simulation, temperature

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Convergence Problem - Transient Simulation gemxx Main CFD Forum 0 July 15, 2018 10:36
Mapping Field Data for Mesh Regions from Another Simulation veterator OpenFOAM Pre-Processing 1 July 10, 2018 06:28
Surface Source - Fixed Temperature? robtheslob FloEFD, FloWorks & FloTHERM 18 May 12, 2017 03:28
Simulation FPEs - turbulence for transient and steady-state? DaveR OpenFOAM Running, Solving & CFD 5 March 5, 2017 16:06
setting up a simulation with multiple interactions phandy OpenFOAM Running, Solving & CFD 1 October 6, 2014 04:16


All times are GMT -4. The time now is 14:24.